FOG/SMOKE MACHINES

V-929 MAXI FOGGER

FOG MACHINE USER MANUAL

READ AND SAVE THESE INSTRUCTIONS

CAUTION: Risk of burn, fire or electrical shock. Read instructions before using!

Precautions:

1.   To reduce the potential risk of fire, electric shock, or injury, place the fogger on a flat, firm, and level surface.

2.   To reduce the potential risk of electric shock, do not overfill the liquid tank.

3.   To reduce the potential risk of electric shock, disconnect the power supply cord before cleaning the fogger.

4.   For indoor use only. Protect the machine from moisture and rain.

5.   Do not obstruct the nozzle. Keep a minimum distance of 2 feet between nozzle and people.

6.   Never aim (the nozzle/machine) directly at people.

7.   Be sure to leave enough space for good ventilation, keep away from other objects.

8.   Keep away from children.

9.   Keep away from flames, flammable, and explosive substances to avoid fire or explosions.

10.     Never use the machine if there is a leak, or the liquid in the tank has over flown.

11.     Fill the liquid tank carefully to avoid overflow which may cause an electrical shock.

12.     Switch off the machine when not in use.

13.     For any other question please contact your store/source where you purchased the machine.

14.     No user serviceable parts inside, please refer to your source of purchase or qualified technician

15.     Use water based fog liquid ONLY! For best results use FJ-1 or FJ-1Q fog juice.

Operating Directions:

1.   Remove all the packing before use. If the machine is broken or parts are missing, immediately contact source of purchase!

2.   Place the machine horizontally on a firm and level surface. Pour the fog juice into the tank.

3.   Connect the machine with properly grounded power supply (120VAC).

4.  Plug the remote into the fog machine’s remote socket.  Press the red button (POWER). The red indicator on the remote will light up. The POWER button should always be pressed down.

5.  Press the yellow button (TIMER) and adjust the fogging “interval” and “duration” knobs. DURATION controls fogging time (0.5～10 seconds) and INTERVAL controls the time between each fogging (10-200 seconds). 

6.   When ready, the green button (MANUAL) will light up. This overrides all the buttons. Press down (MANUAL ) green button to immediately fog at maximum volume.

7.   Wait till the indicator on the remote comes on, before pressing the button for fog.

8.   It is normal for your fogger to have a recycling period after long bursts. At this point the unit will shut itself down for a short period in order to reheat. During this time no fog can be produced.

9.   Turn off the machine before refilling the tank.

Normal Exceptions and Maintenance:

1. Check and make sure to refill fog juice once tank is empty. Pump and other components will be damaged if fog machine continues running when there is no liquid in the tank.

2.  Use only water based fog juice. FJ-1 or FJ-1Q fog juice is recommended.

3.  Run distilled water through the machine after each use. If fogger shows signs of slowing/clogging use UNCLOGIT( recommended) liquid to clean the fog machine.

4.  Empty the tank, and then pour UNCLOGIT liquid instead of fog juice into the tank and run the liquid through as if you were making fog (for about 20-30 seconds).

5.  Unplug the power if fog machine will not be used for long periods of time.

6.   While on, it is normal for fogger to occasionally emit some puffs of fog.

TECHNICAL SPECIFICATIONS:

Voltage: AC 120V/60HZ                              Tank: 1.5 Liters

Heater: 1000W                                           Size: L430xW200xH210mm

Fuse: 125V  8A                                           Warm-up time: 6 minutes

BACK